Another new tool in the Lishi standard key 2in1 range , another lock that has proved for some locksmiths a chore to strip and decode , its another quick and simple tool to use with a very accurate decode.
With 9 positions and just 3 heights to deal with , it is a very simple lock to defeat and decode. The tool prefers a light to medium tension and no proven sequence picking procedure has been identified, it is a simple procedure of picking the binding wafer and moving on to the next binding wafer until the lock is open.
The pick is of the design of 2 separate wafer lifters , one for the odd numbered wafers and one for the even number wafers.
The Picking procedure
Insert the Lishi pick into the lock , with no tension , check a wafer can be felt in each position, if so we are ready to begin picking the lock . Apply a light to medium tension via the tension handle and position the pointer on position 1 line, gently lift the wafer along the line just 1mm, if resisting pick it, if moving then leave it alone and move to the next position and check this the same, do this for each position , picking the binding wafer each time until the lock is open.
When picking a binding wafer , only lift it 1mm , if still binding then lift again another 1mm until moving and returning on the spring in a tight slapping motion, NEVER PICK A WAFER THAT IS MOVING , LEAVE THESE ALONE !
1st to bind and be picked is the 1 position
2nd to bind and be picked is position 7
3rd is position 9
4th is position 5
5th is position 1 again
6th is position 8
7th to pick is position 6
8th to pick is position 4
Last to pick is position 6 again and locks open.
In order to decode the lock , it needs to be held in the fully open position via the tension handle.
The Decoding process
As a lishi tool design with the 2 separate lifters for odd and even numbered rows , the lock decodes in the same direction as picked .
Whilst holding the lock in the fully open position via the tension handle, position the lifters pointer on the No 1 line and move it along the line until it stops, it will stop on one of the cut lines, which will be the cut for that position, position 1 refers to the bow end of the key and position 9 refers to the tip end of the key.
Position 1 is a No 2 cut
Position 2 is a number 1 cut
Position 3 is a cut No 3
position No4 is a number 2 cut
Position 5 is a No 2 cut
Position No 6 is a No 1 cut
Position 7 is a No 1 cut
Position 8 is a No 1 cut
Position 9 is a No 3 cut.
So the decode and the key for this lock from bow end to tip end of the key is ,
2 , 1 , 3 , 2 , 2 , 1 , 1 and 3 , so the key is from bow to tip 21322113 , this can now be cut to code and programmed to the car.
LISHI GT15 2 in 1 Auto Pick and Decoder for Fiat
This is from blog.chinacardiags.com:GT15 Fiat Lock Picking & Decoding with Lishi 2in1
留言列表
